LifeSpan TR8000i Owner's Manual page 16

Step 7: Medical Handlebar (optional)
(If not attaching the medical handlebars skip to step 8)
1. Un-package the Handlebars
A. Open carton, remove and un-package all components.
B. Check to be sure all components are present. The carton contains 1 left handlebar, 1 right handlebar,
and a hardware kit.
The hardware kit includes:
1- Left Handlebar End Cap
1- Right Handlebar End Cap
4 - M6*15 Allen Bolts
8 - M8*20 Allen Bolts
8 - M8 Lock Washers
8 - M8 Flat Washers
2. Remove the Original Handlebar end caps (2) from the Pro Series Treadmill
A. Remove the two screws (1), located under the handlebar, holding the end cap on.
B. Use a small screw driver to remove the end caps (2).
C. The treadmill will need to be raised in the back or laid on its side in order to attach the medical
handlebars. If raising the back end up, it is good to have the back end at least one foot off the ground
Note:
The assembly instructions are written as if the treadmill is raised in the back.
16
2
1