Table of Contents
Advertisement
Inspection and transport
Procedure
1. Unpack the EVSE. Refer to section 4.2.2.
2. Do a check on the transport sensors. Refer to section 4.2.3.
3. Do a visual check for damage on the outside and inside of the EVSE.
4. Make sure that all parts are delivered. Refer to the section 11.2.
5. If you find damage or the parts are not according to the order, contact the
on-site representative of the manufacturer.
4.2.2
Unpack the EVSE
1. Remove the packaging material.
2. Discard the packaging material. Refer to section 2.11.
3. Remove the EVSE from the pallet.
4.2.3
Do a check on the transport sensors
Preliminary requirements
Procedure
1. Do a check on the sensors (A) that
record the shocks during transport.
2. Do a check on the sensors (B)
that record the maximum tilt during
transport.
3. If the sensors (A) show a red
indication or the sensors (B) show a
tilt that is too high, do these steps:
For the transport specifications, refer
to section 11.12.
a. Refuse the delivery of the EVSE.
b. Make a note on the delivery
c. Within three days of the delivery,
d. If you see damage on the EVSE, through the packaging material, do not
e. Contact the manufacturer and give details of the delivery problems. Refer to
4.3
Packing
4.3.1
Pack the EVSE
Preliminary requirements
32
•
Installation engineer
receipt.
ask the transport company for an inspection.
unpack the EVSE.
section 1.12.
•
The EVSE is disconnected.
Refer to section 8.
A
B
TiltWatch PLUS
ShockWatch
TiltWatch PLUS
ShockWatch
A
B
•
Installation engineer
9AKK108467A6997-EN | 003
Advertisement
Table of Contents
