Table of Contents
Advertisement
DT4240 xx xx xx xx
Wiring plan, connecting
the analogue output
(see also "Application
example")
Be careful the polarity of
the cables.
20230503-V0
5.5. Connecting the analogue output (option).
The following figure shows the wiring plan, connecting
analogue output in case of active (DT4240 xx xx IA xx) or in
case of passive (DT4240 xx xx IP xx) output:
1. Loosen terminal screws.
2. Insert the wire ends into the open terminals according to
the wiring plan.
3. Screw the terminal in.
4. Check the hold of the wires in terminals by pulling on
them firmly.
17
Advertisement
Table of Contents
