Table of Contents
Advertisement
6.3
Installation on the beam
Hoists according to table 1
Assemble the side plates (1) of the trolley with
load bars (2), distance tubes (5), washers (6),
hexagon nuts (3) and lock nuts (4) to width "X".
Tighten the hexagon nut (3) and lock nut (4)
thoroughly.
Push on the trolley at the face of the beam
flange.
Insert the threaded rod (9) through the
corresponding holes.
At first tighten the nut (10) and than the nut
(11).
Should it not be possible to push the trolley onto the beam due to lack of space available - the trolley
can also be mounted on the beam from below.
Screw on the hexagon nut (3) and the lock nut at the side of the gear.
The trolley halves must be separated until the trolley can be pushed over the track beam flange from
below.
Push the trolley together again until it reaches the correct wheel gauge.
Secure the washers (6) and distance tubes (5) by tightening the hexagon nuts (3) and the safety nuts (4).
Insert the threaded rod (9).
Tighten nut (10) first, then nut (11).
The trolleys are moved by four wheels. The axis of the driven wheel is set slightly lower to ensure the
required wheel pressure for traversing when the device is not under load.
To prevent the slack between load bolt (2) and the corresponding bores which is due to the manufacturing
process, having a negative impact on wheel pressure, proceed as follows:
Place a 2 mm thick sheet metal strip each under the 3 wheels which are not driven, loosen nuts (3,4) and
(11) slightly.
Charge the device at the load hook until the trolley wheels have pressure.
Afterwards, tighten all nuts and lock nuts again.
6.4
Installation on the beam
Hoists according to table 2
The hoists are a adjusted to a beam flange width
in the factory and the bottom blocks are not
adjustable afterwards.
The bolt is secured/locked with a locking ring (A).
For corrections of the flange width adjustment or
during assembly of the units to the beam:
Remove the lock screws and the locking rings
(A).
Push apart the trolley halves.
After adjustment of the width "X", assemble the
locking rings (A) and lock screws again and
tighten them.
5.52.182.01.01.05
Illustration 7
Illustration 8
15
Advertisement
Table of Contents
