Table of Contents
Advertisement
10
Install a new sag indicator o-ring.
Install a new sag indicator o-ring.
11
Tighten the Schrader valve core.
Tighten the Schrader valve core.
12
Pressurize the shock to around 50 psi / 3.5 bar.
Pressurize the shock to around 50 psi / 3.5 bar.
Final air pressure should be set after the shock is installed onto the
Final air pressure should be set after the shock is installed onto the
bicycle and the spring sag is determined, or as recommended by the
bicycle and the spring sag is determined, or as recommended by the
frame manufacturer.
frame manufacturer.
13
Install the air valve cap.
Install the air valve cap.
This concludes service for your RockShox rear shock.
This concludes service for your RockShox rear shock.
RockShox Schrader valve tool
RockShox shock pump
50 psi / 3.5 bar
73
IsoStrut Air Can Installation
Advertisement
Table of Contents
