Table of Contents
Advertisement
10
Tighten the sealhead/air piston to the specified torque.
Tighten the sealhead/air piston to the specified torque.
Do not scratch the damper shaft while tightening the sealhead/air
piston. Scratches can cause leaks.
To prevent damage to the damper body, do not allow the wrench to
slip from the sealhead/air piston.
11
Allow oil and air bubbles to escape from the bleed port.
Allow oil and air bubbles to escape from the bleed port.
Wipe away excess oil around the sealhead.
Wipe away excess oil around the sealhead.
Insert a NEW nylon compression ball into the bleed port. Allow
Insert a NEW nylon compression ball into the bleed port. Allow
the nylon compression ball to settle into place below the threads.
the nylon compression ball to settle into place below the threads.
Additional air and/or oil will displace.
Additional air and/or oil will displace.
NOTICE
19 mm or adjustable wrench
28 N∙m (250 in-lb)
64
IFP Installation and Bleed
Advertisement
Table of Contents
