Toyota Grand Highlander 2024 Manual page 35

ing and stowing the seat belt.
3
Stow the plate
the holder on the roof.
In order to securely stow them,
firmly insert them as far as possi-
ble.
Adjusting the seat belt
shoulder anchor height
(front seats)
1
Push the seat belt shoulder
anchor down while pressing
the release button
2
Push the seat belt shoulder
anchor up while pressing the
release button
Move the height adjuster up and
down as needed until you hear a
click.
Adjustable shoulder anchor
■
Always make sure the shoulder
belt is positioned across the cen-
ter of your shoulder. The belt
and in
should be kept away from your
neck, but not falling off your shoul-
der. Failure to do so could reduce
the amount of protection in an
accident and cause death or seri-
ous injuries in the event of a sud-
den stop, sudden swerve or
accident.
Seat belt pretensioners
(front and outboard sec-
ond seats)
When the vehicle is subjected to
a severe frontal or side impact
or rollover, the pretensioners
retract the seat belts of the front
seats and rear outer seats to
securely restrain the occupants.
The pretensioners will not operate
in minor frontal or side impacts, or
rear impacts.
Replacing the belt after the pre-
■
tensioner has been activated
If the vehicle is involved in multiple
collisions, the pretensioner will acti-
vate for the first collision, but will not
activate for the second or subse-
quent collisions.
PCS-linked control
■
. If the PCS (Pre-Collision System)
determines that the possibility of a
1-1. For safe use
.
WARNING
35
1