Table of Contents
Advertisement
198
4-1. Before driving
A
Trailer ball load rating
Matches or exceeds the gross
trailer weight rating of the trailer.
B
Ball diameter
Matches the size of the trailer cou-
pler. Most couplers are stamped
with the required trailer ball size.
C
Shank length
Protrudes beyond the bottom of the
lock washer and nut by at least 2
threads.
Shank diameter
Matches the ball mount hole diame-
ter size.
Positions for towing hitch
receiver and hitch ball
A
Weight carrying ball position:
50.63 in. (1286 mm)
B
Hitch receiver pin hole posi-
tion: 44.25 in. (1124 mm)
Connecting trailer lights
(if equipped)
Use the wire harness stored in
the rear end under body.
■
Auto current cut-off function
In case of over current, the auto
cut-off function stops the power
flowing to the trailer lights to prevent
damage to the vehicle's electrical
system.
This function is activated when the
rated current of any of the following
trailer light circuit components is
exceeded:
●
Tail lights: maximum 8.0 A
●
Stop/turn signal light (right): maxi-
mum 5.0 A
●
Stop/turn signal light (left): maxi-
mum 5.0 A
■
When the auto current cut func-
tion is activated
If a trailer light does not come on
due to the activation of the auto cur-
rent cut function, the light system
will need to be reset.
Follow the reset procedure shown
below.
●
If a tail light does not come on,
turn off the headlight switch.
●
If the right-side stop/turn signal
light does not come on, put the
turn signal in the off position or
remove foot from the brake pedal.
●
If the left-side stop/turn signal light
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
