Toyota Grand Highlander 2024 Manual page 174

174
3-6. Favorite settings
door lock switch (either lock
or unlock) until the buzzer
sounds.
If the button could not be regis-
tered, the buzzer sounds continu-
ously for approximately 3 seconds.
 Driving position recall proce-
dure
1
Make sure that the doors are
locked before recalling the
driving position. Carry the
electronic key that has been
registered to the driving posi-
tion, and then unlock and
open the driver's door using
the smart key system or wire-
less remote control.
The driving position will move to the
recorded position (not including the
head-up display [if equipped]).
If the driving position is in a position
that has already been recorded, the
seat and outside rear view mirrors
will not move.
2
Turn the engine switch to
ON.
The head-up display (if equipped)
will move to the recorded position.
 Memory recall function can-
celation procedure
Carry only the key you want to
cancel and then close the
driver's door.
If 2 or more keys are in the vehi-
cle, the driving position cannot
be canceled properly.
1
Check that the shift position
is in P.
2
Turn the engine switch to
ON.
3
While pressing the "SET" but-
ton, press and hold the door
lock switch (either lock or
unlock) until the buzzer
sounds twice.
If it button could not be canceled,
the buzzer sounds continuously for
approximately 3 seconds.
■
Recalling the driving position
using the memory recall func-
tion (vehicles with the My set-
ting)
Different driving positions can be
registered for each electronic key.
Therefore, the driving position that
is recalled may be different depend-
ing on the key being carried.
■
Recalling the driving position
using the memory recall func-
tion (vehicles without the My
setting)
●
Different driving positions can be
registered for each electronic key.
Therefore, the driving position that
is recalled may be different
depending on the key being car-
ried.
●
If a door other than the driver's
door is unlocked with the smart
key system, the driving position
cannot be recalled. In this case,
press the driving position button
which has been set.
■
Jam protection function
While the driving position is
recalled, if an object is stuck behind