Toyota Grand Highlander 2024 Manual page 222

222
4-3. Operating the lights and wipers
roundings. This may cause the
low beams to remain on or the
high beams to flash or dazzle
pedestrians or vehicles ahead. In
such a case, it is necessary to
manually change between the
high beams and low beams.
• When there are lights similar to
headlights or tail lights in the sur-
rounding area
• When headlights or tail lights of
vehicles ahead are turned off,
dirty, changing color, or not aimed
properly
• When the headlights are repeat-
edly changing between the high
beams and low beams.
• When use of the high beams is
inappropriate or when the high
beams may be flashing or daz-
zling pedestrians or other drivers.
• When the vehicle is used in an
area in which vehicles travel on
the opposite side of the road of
the country for which the vehicle
was designed, for example using
a vehicle designed for right-hand
traffic in a left-hand traffic area, or
vice versa
• When it is necessary to disable
the system: P.235
• Situations in which the sensors
may not operate properly: P.240
■
Temporarily reducing front
camera sensitivity
The sensitivity of the front camera
can be temporarily reduced.
1
Turn the engine switch off with
the following conditions met.
●
The headlight switch is in the
or position.
●
The headlight switch lever is in the
low beam position.
●
The Automatic High Beam switch
is on.
2
Turn the engine switch to ON.
3
Within 60 seconds after perform-
ing step 2, push the headlight
switch lever to the high beam
position then pull it to the original
position quickly 10 times, then
leave the lever in its original posi-
tion.
4
If the sensitivity is changed, the
Automatic High Beam indicator
will blink 3 times.
Turning the high beams
on/off manually
■
Changing to the high
beams
1
Push the lever forward.
The AHB indicator will turn off and
the high beam indicator will turn on.
Pull the lever to its original position
to enable the Automatic High Beam
system again.
■
Changing to the low beams
1
Press the Automatic High
Beam switch.
The AHB indicator will turn off.
Press the switch to enable the
Automatic High Beam system
again.