Changing The Password; Troubleshooting - oventrop Regtronic KM IP Installation And Operating Instructions Manual

7.24 Changing the password

In order to change the user password of the Web interface, proceed as follows:
1. In the Configuration main menu, select the Users submenu.
2. Under Change password click the toggle button.
3. Enter the current password into the Password field.
The default password can be found on the underside of the housing (Web-
Interface).
4. Enter the new password into the New password field.
5. Enter the new password into the Confirm new password field.
6. Click Save configuration.
8

Troubleshooting

Problem Solution
The user password is When the user password is not available, the device has
not available. to be reset to its factory settings in order to regain ac-
cess to the Web interface. The password can be found on
the underside of the housing (Web-Interface).
Signal strength of the Î Use the device in another location.
WLAN too low.
The S-Bus cable can be extended to up to 50 m.
The status LED is If all network settings are changed, it might occur that the
green although no con- status LED is not able to signal this change.
nection is available.
Î Restart the device.
Problem Solution
The device is Check the following points in order to find and eliminate
not found by the the error.
DeviceDiscoveryTool.
Î Check if the power supply to the device is established.
Î Check if the network cable is properly connected at
both ends!
Î Alternatively check the WLAN connection.
Î Check if the firewall software of the computer inhibits
the connection to the device.
Î Switch off the firewall software and use the Device-
DiscoveryTool to find the device.
Î When the device has been found, the firewall software
has to be reconfigured.
Î Activate the firewall software!
Î Check if an IP address is assigned to the device.
An IP address has to be assigned to the device by a router.
37