Indication And Operating Elements; Operating Control Led; Button - oventrop Regtronic KM IP Installation And Operating Instructions Manual

4

Indication and operating elements

The following elements are featured on / in the housing of the device:
 Operating control LED
 LAN connector
 Button

4.1

Operating control LED

Operating control LED
The operating control LED indicates the operating status of the device:
LED flashing codes
Colour Permanent
Red S-Bus signal available
Green S-Bus signal and Internet connection
available
Red / green
LED off No mains voltage
28


Flashing
No S-Bus signal
The device is booting
4.2

Button

WLAN LED
LAN LED
With the button, the following functions can be carried out:
• WLAN:
The button can be used for activating or deactivating the WLAN connection, re-
spectively. If the WLAN is activated, the WLAN LED glows orange.
Î In order to activate or deactivate the WLAN, respectively, press the button for
approx. 1 s.
• Reset:
The button can be used for carrying out a reset in order to set back the configu-
ration of the device to the factory settings.
Î In order to reset the device, press the button for approx. 20 s.
The device will restart, the settings and passwords set back to factory settings. This
process may take several minutes.
Button