Kind 3 (12-21) - Uniphone ISDK-26 Basic Installation & Programming Manual

Kind 3 (12-21)

Item
12 Outward call restriction
While hunting a new CO line, hang up the
13
last hunted CO line
Digital keyphone transmittal control by
14
the dialling digits
15 Enable to hold the CO line
The respondent route after holding time is
16
out
The respondent route after camp-on time is
17
out
The respondent route of the transferee's
18
station after no-answer time is out
The respondent route for no-answer the
19
transferred recall
20 Metering way of billing
Invalid dialling duration after ended the
21
call
Description Default
0: No (If connect CO line to another PBX)
1: Yes
1
Related program: K1 item 33-38, K2 item 38-41.
0: Switch to "transfer" status (for conference call)
1 1: Auto hang up (The original line will hang up if
press new CO line key)
0: Uncontrolled
Setting value: 1-19 digits
0
The digital keyphone will not route the call if
the dialling digits less than the setting value.
0: No (when connected with external amplifier or
doorphone.)
1
1: Yes (Allow the station to keep the trunk line by
pressing "HOLD")
Refer to K1 item 21 to set the holding time
0: Hang up the call
1: Recall the holding station
1
2: Recall the designated station A (Refer to K1
item 15)
3: No recall
Refer to K1 item 13 to set the camp-on time.
0: Hang up the call
1: Recall to the transferor station
1
2: Recall to the designated station A (Refer to K1
item 15)
3: No recall
Refer to K1 item 19 to set the recall time.
0: Hang up the call
1: Recall to the transferor station
1
2: Recall to the designated Station B (Refer to K1
item 16)
3: No recall
0: Hang up the call (ringing duration K1 Item19)
0
1: Keep ringing till it is answered
0: Line connected (Billing after connecting the
line even if no one answer the phone)
1: Polar reverse (Billing after speaking)
2: Polar reverse again after the speaking is over.
0
(Billing after speaking and then hang up the
line automatically after speaking is over.)
Note: 1,2 only available when the trunk card is
including the polarity reversal.
0-9999 ms
Application: To make sure the CO line is cut or to
0001
prevent another user to retrieve the just hang-up
CO line within the limited duration.
50
Instruction