Programming Guide; Programming Instruction; Set To Default Parameter/Value; Method 1 - By The Programming Clear Code - Uniphone ISDK-26 Basic Installation & Programming Manual

2. PROGRAMMING GUIDE

2.1 Programming Instruction

After finished the hardware installation, please set to default parameter/value before
program the system.
A. Set to default parameter/value.
B. Access to system program by keyphone or PC-programming software.
C. RS-232 is necessary if you want to program via PC-programming software.

2.2 Set to Default Parameter/Value

2.2.1 Method 1 - By the programming clear code

Please note that this method only available on the first 15 minutes after turn the
power on. Enter the programming clear code (**3721286321) to set to default
parameter/value. After power "ON", within 15 minutes:
ON
1

2.2.2 Method 2 - By DIP Switch

Switch the DIP-switches 1,2,3 off and DIP-switch 4 ON, then press "Reset" key
 CLEAR ALL  switch DIP-Switch 1, 2, 3,4 ON to prepare for the new
programming.

2.3 Start to Program

Enter programming setting code (2656) to set up required programming data. To enter the
programming kind number at first, then enter the required item.
Operation:
Remarks: PGM VER 6.XX means "VERSION 6.XX of the system software". It will be
updated without notice.
DIP ON
2 3 4
1 2
Are you sure?
6
ON DIP
1 2 3 4
1
4 2
2 times
in 1sec.
3 4
#
7
2
or setting
6 5 6
password
22
3 7 2 1 2 8 6 3 2 1
Clear Code
5
CLEAR ALL
ON
1
3
**PGM VER 6.XX**
LCD
Welcome ISDK SET
screen:
8
DIP
2 3 4
4