Powering The Projector Off - Christie DWU500S User Manual

Powering the projector off

To turn off the projector, do the following:
1. Press the button either on the built-in keypad or on the IR remote keypad to turn off the
projector.
2. At the confirmation prompt, press the
Otherwise, the message disappears after 10 seconds. When pressing the
second time, the fan starts cooling the system and the projector shuts down. The cooling fans
continue to operate for approximately four seconds for the cooling cycle and the Power LED
flashes red.
When the Power LED is solid red, the projector has entered Standby mode.
To turn the projector back on, you must wait until the projector has completed the cooling cycle
and has entered Standby mode. Once in Standby mode, press the
projector.
3. Disconnect the power cord from the electrical outlet and the projector.
DWU500S User Manual
020-001919-02 Rev. 1 (07-2021)
Copyright ©2021 Christie Digital Systems USA Inc. All rights reserved.
button again.
Installation
button for the
button to restart the
21