Powering The Projector On; Powering The Projector Off - Christie E SERIES User Manual

3.3

Powering the Projector ON

1. Ensure that the power cord and signal cable are securely connected. The
Status LED is solid yellow.
2. Turn on the lamp by pressing
keypad. The Status LED is yellow with a long blink.
The startup screen displays in approximately 10 seconds.
3. Turn on the source. Select Input Key on the remote control to select an
input source (VGA1, VGA2, BNC, HDMI1, HDMI2, Component, S-Video or
Composite Video).
4. The projector detects the source you selected and displays the image.
NOTE:
 The first time the projector is used, the preferred language may be selected from the main menu after the startup screen is
displayed.
USB RS232 IN Wired Keypad DC5V
Ethernet VGA-OUT 1-VGA
3.4

Powering the Projector OFF

1. Press
projector. A warning message will appear on the displayed image.
2. Press
the warning message will disappear after 10 seconds.
E Series User Manual
020-000287-01 Rev. 1 (01-2011)
Downloaded from ProjectorsManual.com Manuals
1 2 3
11 12 13 14 15 16 17 18 19 20
Power LED
1 2 3 4 5
11 12 13 14 15 16 17 18 19 20
DC12V SVID CVBS Green/Y
2-VGA 1-HDMI 2-HDMI
on the built-in keypad or on the remote control to turn off the
" "
again to confirm your selection. If you do not press
" "
1 2 3 4 5 6 7
11 12 13 14 15 16 17 18 19 20
on the remote control or on the built-in
" "
4 5 6 7 8 9 10
6 7 8 9 10
Blue/Pb Red/Pr Power on
1 2 3 4 5 6 7
11 12 13 14 15 16 17 18 19 20
R G B H/C V
Section 3: Installation
8 9 10
1 2 3 4 5
11 12 13 14 15 16 17 18 19 20
Input Key
1 2 3 4 5 6
8 9 10
11 12 13 14 15 16 17 18 19 20
6 7 8 9 10
Power on
1 2 3 4 5 6 7 8 9 10
11 12 13 14 15 16 17 18 19 20
7 8 9 10
again,
" "
3-3