Powering The Projector On/Off; Powering On The Projector - Christie CAPTIVA DUW350S User Manual

Section 3: iNSTallaTioN
3.2

Powering the Projector On/Off

3.2.1
1.
2.
3.
4.
™
™
16

Powering On the Projector

Securely connect the power cord and signal cable. When connected,
the POWER/STANDBY LED turns Orange.
Turn on the projector by pressing
or on the remote. At this moment, the POWER/STANDBY LED turns
Blue.
The startup screen will display in approximately 5 seconds. The first
time you use the projector, you will be asked to select the preferred
language and power saving mode.
Turn on and connect the source that you want to display on the
screen (computer, notebook, video player, etc). The projector
detects the source automatically. If not, push menu button and go to
"OPTIONS".
Make sure that the "Source Lock" has been set to "Off".
NOTE:
If you connect multiple sources at the same time, press the "INPUT" button on the control panel
or direct source keys on the remote control to switch between inputs.
When the power mode is in standby mode (power consumption < 0.5W), the VGA output/input
and audio are deactivated when the projector is in standby.
1
POWER/STANDBY
" " button either on the projector
CAPTIVA DUW350S/CAPTIVA DHD400S User Manual
020-000816-01 Rev. 1 (07-2015)