Installing Drive Belt - Segway AT5 S Owner's Manual

MAINTENANCE, STORAGE AND TRANSPORTATION
CVT belt
marking

INSTALLING DRIVE BELT

Ensure that the new belt direction is consistent with the original belt
• The installation procedure is basically the opposite of the
disassembly.
• Wrap the drive belt around the CVT drive wheel and drive wheel.
• Pull out the kick-out pin from the drive wheel and tighten the
CVT driven wheel.
• Install the CVT seal ring and tighten the CVT cover.
Torque
4. With the kit-out pin for
driven pulley(special tool)
against the driven wheel as
shown in the figure of the hole,
make the driven wheel open.
Before removing the drive belt,
please note the direction of the
marks on the drive belt (such
as manufacturer name, arrow
mark, etc.) so that the drive
belt can be reinstalled on the
pulley in the original direction.
5. Take out the drive belt
to be replaced and clean
up the debris in the CVT
compartment.
CAUTION
!
installation direction.
CVT outer cover bolt：10 Nm
103
WARNING
!