Segway AT5 S Owner's Manual page 40

VEHICLE DEVICE
NOTICE
The vehicle must be stopped to engage or disengage 2WD/4WD switch.
Mechanical damage may occur if switch is engaged
or disengaged when driving.
2×4 Two-Wheel Drive Mode
Rotate the selector handle downwards (to Position ) to engage
3
two-wheel drive mode. The whole vehicle is only driven by the
rear wheels now, and the front wheels have no power output.
The drive symbol " " is displayed on the instrument panel.
4×4 Four-Wheel Drive Mode
Rotate the selection handle upwards (to Position ) to engage
4
four-wheel drive mode. Front wheels have power output, and the
rear wheels have power output. The four-wheel drive symbol
" " is displayed on the instrument panel. This mode is suitable
for bad road conditions and muddy / hilly areas.
Front Axle Lock Mode
When selector handle is in 4x4 position, press the front axle lock
switch. Front axle lock switch pops up and the front axle lock
symbol " " will be displayed on the instrument panel. At this
time is working 4-wheel drive lock mode. Front wheels have
power output, and the rear wheels have power output. The tires
on both sides rotate the same speed and with same power. When
the 4WD is locked, the vehicle will be in the speed limit mode,
the speed does not exceed 30 km/h. This mode is suitable for the
vehicle to get out of trouble.
33