TESY EVHP 9S 260 60 Instructions For Use Manual page 30

1. INTRODUCTION
This installation and maintenance manual is to be
considered an integral part of the TESY heat pump
(hereafter referred to as equipment).
The manual must be kept for future reference until the
heat pump itself has been dismantled. This manual is
intended for both the specialized installer (installers –
maintenance technicians) as well as the end user. The
installation modes to be complied with in order to achieve
a correct and safe operation of the equipment as well as
methods of use and maintenance are described in this
manual.
In case of the sale of the equipment or the change of
owner, the manual must accompany the equipment to its
new destination.
Before installing and/or using the equipment, read this
instruction manual carefully and, in particular, chapter 4
relating to safety.
The manual must be kept together with the equipment
and, in any case, it must always be at the disposal of the
qualified personnel in
maintenance.
The following symbols are used inside the manual in
order to rapidly find the most important information:
Information on safety
Procedures to follow
Information/ Suggestions
1.1. TESY products
Dear Customer,
Thank you for having purchased this product.
TESY, has always paid a great deal of attention to
environmental problems,
technologies and materials with a low environmental
impact to manufacture its products in conformity with
–
RAEE ROHS (2002/95/CE
community standards.
1.2. Disclaimer
The conformity of the content of these user instructions
with hardware and software has been submitted to
thorough verification. Regardless of this, it is still possible
for some non-compliance to occur; therefore, no liability
will be assumed for complete conformity.
In the interest of achieving technical perfection, we
reserve the right to carry out modifications to the
equipment construction or to data at any time whatsoever.
Therefore we do not accept any liability claims
whatsoever attributable to instructions, figures, drawings
or descriptions, without prejudice to errors of any kind.
TESY shall not be held responsible for damages
attributable to misuse, improper use, or as a consequence
of unauthorized repairs or modifications.
charge of installation
therefore, it has
and 2003/108/CE)
WARNING!: The equipment can be used
by children of at least 8 years of age as
well as by people with reduced physical,
sensory or mental abilities or by those
who lack the necessary experience or
knowledge,
supervised or after they have received
instructions relating to the safe use of
the equipment as well as explanations
relating to the use of such equipment.
Children
equipment. Cleaning and maintenance
intended to be carried out by the user
must not be performed by unsupervised
children.
1.3. Copyright
These user instructions contain information protected by
copyright. It is forbidden to photocopy, duplicate, translate
and
or record these user instructions on memory equipment,
either in whole or in part without prior authorization of
TESY. Any breaches shall be subject to the payment of
compensation for any damage caused. All rights are
reserved, including those deriving from the issuing of
patents or the registration of utility models.
1.4. Operating principle
The equipment belonging to the EVHP series is capable
of producing domestic hot water mainly by using heat
pump technology. A heat pump is
transferring thermal energy from a low temperature
source to another with a higher temperature and vice
versa (heat exchangers).
The equipment uses a water circuit consisting of a
compressor, an evaporator, a condenser and a throttle
valve; a liquid/gas coolant flows inside this circuit (see
paragraph 4.6).
The compressor creates a difference in pressure inside
the circuit that allows a thermodynamic cycle to be
obtained: this sucks the coolant fluid in through an
evaporator, where the fluid itself evaporates at a low
pressure by absorbing heat; it is compressed and driven
used towards the condenser where the fluid condenses at a
high pressure releasing the absorbed heat. After the
condenser, the fluid passes through the so-called "throttle
valve" and by losing pressure and the temperature starts
to vaporize, it re-enters the evaporator and the cycle
starts all over again.
as long as they
must not play with
capable of
are
the