Page 1
Write the serial number in the space above for future reference. Serial Number Decal (inside tower) UESTIONS? At FreeMotion Fitness, we are committed to providing com- plete customer satisfaction. If you have questions, see HOW TO CONTACT CUSTOMER CARE on the back cover of this manual.
To reduce the risk of serious injury, read all the important precautions and instructions in this manual and all warnings on the strength equipment before using the strength equipment. FreeMotion Fitness assumes no responsibility for personal injury or property damage sustained by or through the use of this product.
WARNING DECAL PLACEMENT The decals shown below have been placed on the strength equipment in the indicated locations. If a decal is missing or illegible, see HOW TO CONTACT CUSTOMER CARE on the back cover of this manual and order a free replacement decal. Apply the decal in the location shown. Note: The decals may not be shown at actual size.
BEFORE YOU BEGIN Thank you for selecting the FREEMOTION ® EPIC™ after reading this manual, see HOW TO CONTACT BICEP strength equipment. The BICEP strength equip- CUSTOMER CARE on the back cover of this manual. To ment features quality craftmanship and an innovative...
ADJUSTMENT This section explains how to adjust the strength equipment. Make sure that all parts are properly tightened each time the strength equipment is used. Replace any worn parts immediately. ADJUSTING THE RESISTANCE To change the amount of resistance for your workout, insert the weight pin into the desired weight.
Personnel must also record and report any accident. To maintain the strength equipment’s warran- ty, use only FREEMOTION EPIC parts for repair or replacement. If there are any questions or concerns, see HOW TO CONTACT CUSTOMER CARE on the back cover of this manual.
Page 8
Cable Traps tion is begun. Ideally, the cable should not move more Check the cable traps to ensure that they are not rub- than 1/2 in. (1.3 cm) from the resting position before bing against the cable and that they are holding the the top weight is lifted.
Page 9
Top Weight Adjustment 3. Pull the cable out of the top weight coupler. Tools required: 5/32” hex key Determine the amount that the cable needs to be shortened, and cut that much off the end of the 1. If the cable needs to be shortened 3/4 in. (2 cm) cable.
Page 10
WEIGHT STACK SERVICING 9. Reattach the cable to the top weight coupler. Servicing the weight stack involves replacing the two Retighten the four set screws into the threaded guide bushings and weight insert in the top weight. To holes. Tighten the set screws equally until they order these parts, see HOW TO CONTACT CUS- contact the cable.
CABLE DIAGRAM The cable diagram shows the proper route of the cable. Use the diagram to make sure that the cable and the cable traps have been assembled correctly. If the cable has not been correctly routed, the strength equipment will not function properly and damage may occur.
PART LIST—Model No. GZFI8108.0 R0208A Key No. Qty. Description Key No. Qty. Description Frame Handle Ring Tower Pivot Rear Cap Long Pivot Endcap Snap Ring Handle 3/8" x 1 1/4" Screw Handle Grip Stop Cover Weight Guide 3/8" x 1 1/4" Bolt Long Pivot Arm #10 x 1/8"...