Promise Technology VTrak N1616 Product Manual page 22

Promise Technology
5 Connect 1G Network WebPAM Insight Management
In order to use the web-based management interface, WebPAM Insight, it is necessary to connect the
VTrak N1616 to the same switched network as the computer used to manage the system. Note that this
is an optional step, since the device is ready to use as shipped. However, some advanced configuration
options can only be accessed using the WebPAM Insight interface.
1G ports on back of VTrak N1616
The default IP settings on the 1G network interface is DHCP client. If your
network used for management has an active DHCP service, use DHCP on the
computer used for management to simplify IP settings on both systems.
To complete the physical connection to the WebPAM Insight management interface, connect the computer
used for VTrak N1616 management to a 1G network switch, and connect either of the 1G network ports to
the same switch or switched network.
Also keep in mind that both the management computer and VTrak N1616 must be in the same IP subnet.
If your network has DHCP service, this is easily done by setting the computer IP setting to DHCP client.
#2 #1
18
VTrak N1616
Connect either 1G
port to 1G network for
system management
using WebPAM Insight.