Step 8: Testing Your Installation - Xantrex Freedom XC 1800 Owner's Manual

Connecting to the Remote Port
The Freedom XC can accommodate the Freedom X Remote
Panel with cable (PN: 808-0817-01) or with the Bluetooth option
(PN: 808-0817-02) (sold separately; comes with 7.6m-cable) or
the Freedom X Remote Panel unit (PN: 808-0817) (sold
separately; unit only without cable).
To connect the remote panel to the remote port:
Plug the remote panel unit's cable connector to the RJ12
n
Remote port on the unit.
NOTE: When the remote panel is connected, turn the
inverter/charger's Power button to the Standby mode (up
position). This allows the remote panel to control the
inverter/charger's power status.
975-1175-01-01

Step 8: Testing Your Installation

ELECTRIC SHOCK HAZARD
Pressing the Power button to turn the Freedom XC inverter to
Standby mode on the display panel does not disconnect DC or AC
input power to the Freedom XC. If shore power is present at AC
input terminals, it will pass through to the AC output.
Failure to follow these instructions can result in death, serious
injury, or equipment damage.
There are two tests to be performed. The first test verifies that the
Freedom XC is inverting DC battery power and delivering AC
power to its output.
The second test is intended for installations where AC input and
output is hard wired to the Freedom XC. This test verifies that the
Freedom XC transfers from inverter power to shore power when
shore power is present.
NOTE: Shore power (pass-through) refers to the AC input power
from a utility grid, generator or external AC source.
When you are ready to test your installation and operate the
Freedom XC, close the DC fuse and Disconnect or the DC circuit
breaker to supply DC power to the Freedom XC.
Basic Installation Procedures
WARNING
33