Specifications And Components; Specifications And Requirements - Ecosoft MO36000PECO Installer And User Manual

INSTALLER AND USER GUIDE FOR CROSS 90 DIRECT FLOW REVERSE OSMOSIS FILTER
1. PURPOSE OF THE PRODUCT
Inside the membrane, water is separated into two streams: concentrate, which is discharged into
drain, and permeate, which enters next step – post-filter (7).
After opening the purified water valve (3), the pressure in the system drops and the high pressure
switch is activated, opening the inlet valve and starting the pump, automatically resuming the
flow of water through the pretreatment cartridge to the membrane. After opening the purified
water valve (3), the pressure in the system drops and the high pressure switch is activated,
opening the inlet valve and starting the pump, automatically resuming the flow of water through
the pretreatment cartridge to the membrane. The purified water after the membrane enters
the fourth stage of purification — the CB carbon post-filter, designed for final water purification.
The purified water after the membrane enters the fourth stage of purification — the CB carbon
post-filter, designed for final water purification. It contains extruded activated carbon. This filter
improves the taste and smell of the purified water. This filter is direct-flow, so no water storage
tank is required. With a capacity of 600 GPD (90 l/h), it takes only 8 seconds to fill a 200 ml glass.

2. SPECIFICATIONS AND COMPONENTS

2.1 SPECIFICATIONS AND REQUIREMENTS

№ Parameter
1 Main pressure, bar
2 Feed water temperature, °C
3 Flow capacity, l/min
4 Electrical rating
5 Weight of the system, kg
6 Ambient temperature, °C
7 Water supply connection
8 Filter dimensions, H × W × D, mm
* If supply water pressure is below required value, purchase pumped model or fit your existing
filter with booster pump. If the pressure in the water system is above the limit, it is necessary to
install a pressure regulator on the main pipe. If pressure in tank bladder is outside this range, it is
necessary to pump up or release the pressure until it conforms to the requirement.
** If supply water temperature is up in the range of +20...+30 °C, rejection of impurities will be
decreased and system capacity increased, bringing about an increase in TDS. Using the product
with supply water temperature in excess of +30 °C is not recommended.
This manual is the intellectual property of Ecosoft. Copying and reprinting is prohibited. © 2023
Value
2-5*
+5...+30**
1,5
230 V, 50 Hz
11
+5...+40
½" thread
435 х 140 х 458
4