Connection Diagram; Installation Procedure - Ecosoft MO36000PECO Installer And User Manual

INSTALLER AND USER GUIDE FOR CROSS 90 DIRECT FLOW REVERSE OSMOSIS FILTER
3. FILTER INSTALLATION
— verify that your product is as specified in paragraph 2.1;
— verify that your supply water quality** meets the requirements in paragraph 2.2.
**If supply water quality does not meet the requirements, it is necessary to consult with a
water treatment specialist.
3) Before installing the system, make sure there is enough space for the filter rack under the sink.
4) Electrical safety notice: This appliance should be connected into a circuit with an RCB installed.
Please note voltage requirements.
5) Install the system per the guidelines of this manual.
6) The unit is to be supplied with single-phase 230 VAC, 50 Hz electrical power.
The unit is supplied with power cord and can be connected to a properly installed IEC 60884-1
compliant socket. Electrical specification of the unit can be found on manufacturer's factory
sticker. That system and installation must comply with state and local laws and regulations.
3.2 СONNECTION DIAGRAM

3.3 INSTALLATION PROCEDURE

Wash your hands thoroughly with anti-bacterial soap before handling tubes, cartridges, and
membrane.
This system should desirably be installed in places protected from direct sunlight and away
from heating appliances.
This manual is the intellectual property of Ecosoft. Copying and reprinting is prohibited. © 2023
1/4" Red pipe
1/4" White pipe
3/8" White pipe
8