Ecosoft MO36000PECO Installer And User Manual page 10

INSTALLER AND USER GUIDE FOR CROSS 90 DIRECT FLOW REVERSE OSMOSIS FILTER
10
3. FILTER INSTALLATION
5. Connect the drain saddle (6) with drain pipe from
the kitchen sink. The drain saddle is compatible
with most standard drain pipes. Drill a hole of 5.0
mm (0.2") diameter in the kitchen sink drain pipe,
apply rubber gasket with sticky base (included in
the package).
Install the drain saddle (6) on the drain pipe over
the hole. Tighten screws on drain saddle with a
screwdriver. Insert red tube into the connection on
the clamp. Connect the other end of the red tube
with concentrate outlet "Waste" on the connection
panel of the rack. Insert 1/4" quick coupling lock
plate between quick coupling and jack catch of pipe.
1/4" quick coupling
lock plate
1/4" wihte PE pipe in proper lenght
Sewage outlet
CAUTION! If RO systems do not use air gap faucets, it is required that they be plumbed in with
a physical air gap between the waste water outlet and the drain. This is so if the drain backs
up, sewage will not push up into the RO system.
6. Connect one end of 1/4" white tube to
the "Filtered" output on the connection
1/4" quick coupling
panel of the rack. Insert the 1/4"quick
lock plate
coupling lock plate between the quick
connect and the claw of the water inlet
pipe.
1/4" wihte PE pipe
in proper lenght
This manual is the intellectual property of Ecosoft. Copying and reprinting is prohibited. © 2023