Specifications And Components; Technical Specifications; Water Quality - Ecosoft SENSE Installer And User Manual

INSTALLATION AND OPERATION GUIDELINES FOR REVERSE OSMOSIS FILTER ECOSOFT SENSE
6

2. SPECIFICATIONS AND COMPONENTS

2.1. TECHNICAL SPECIFICATIONS

1 Purified water flow rate, L/h
2 Feed water flow rate, L/h
3 Concentrate flow rate, L/h
4 Inlet water pressure, bar (psi)
5 Tank bladder pressure, bar (psi)
6 Feed water temperature, °C (°F)
7 Ambient temperature, °C (°F)
8 Water supply connection
9 Weight, kg, max.
10 Overall dimensions, H × W × D, mm (inch)
11 Tank dimensions, H×W×D, mm (inch)
12 Electrical rating
13 Power consumption, W, max.
14 Ingress protection rating
* At feed water TDS of 1000 ppm and temperature of feed water of 25 °С, ±10%.
** If supply water pressure is below required value, install a pressure booster pump to raise it. If water pressure exceeds the upper limit,
it is necessary to install a pressure regulator on the main pipe.
*** If pressure in tank bladder is outside this range, it is necessary to pump up or release the pressure until it conforms to the requirement.
**** If supply water temperature is up in the range of +20...+30 °C (+68...+86 °F), rejection of impurities will be decreased and system
capacity increased, bringing about an increase in TDS. Using the product with supply water temperature in excess of +30 °C (+86 °F) is
not recommended.

2.2. WATER QUALITY

2.2.1. SUPPLY WATER QUALITY REQUIREMENTS
1 pH
2 TDS
3 Hardness
4 Free chlorine
5 Iron
6 Manganese
7 Chemical oxygen demand
8 Total bacterial count (TBC)
9 E. coli titer
* If water supply does not meet the requirements, service life of membrane and/or pre-filter cartridges may be shortened. If your
home is supplied with raw wellwater, perform laboratory test of your water before installing a reverse osmosis filter. If any of your water
indices exceed the limit, consider using a water treatment system to correct supply water quality. Refer to water treatment specialists or
companies for advice and proper equipment selection.
2.2.2. WATER QUALITY AFTER REVERSE OSMOSIS MEMBRANE
1 pH
2 TDS
3 Calcium
4 Magnesium
5 Sodium + Potassium
* Values are determined under the following conditions: temperature of supply water is 25 °C (77 °F), supply water quality and operation
conditions correspond to manufacturer's requirements.
This manual is the intellectual property of Ecosoft. Copying and reprinting is prohibited. © 2019
Parameter
Index
Index
Value
10-15 *
20-30 *
10-15 *
2-4,5 (29-65) **
0,4-0,6 (5.8-8.7) ***
+4...+30 (+39...+86) ****
+5...+404 (+41...+104) ****
½" thread
15
475x143x480 (18.7x5.6x18.9)
350х260х260 (13.8x10.2x10.2)
220 V, 50 Hz
40
IP 54
Value *
6.5-8.5
<1500 ppm
<500 ppm CaCO3 (<28 °dH)
<0.5 ppm
<0.3 ppm
<0.1 ppm
<5 ppm O2
<50 CFU/mL
<3
Value *
5.5-6.5
5-15 ppm
<2 ppm
<1 ppm
<5 ppm