First Time Use; Steps After Installation - Ecosoft MO36000PECO Installer And User Manual

INSTALLER AND USER GUIDE FOR CROSS 90 DIRECT FLOW REVERSE OSMOSIS FILTER
3. FILTER INSTALLATION

3.4. FIRST TIME USE

1. Turn on the feed water valve (4).
2. Connect the machine to the power supply. When the machine is powered on, the buzzer will
sound for 0.1 seconds, and the four indicator and the indicator on the purified water faucet will
light up in turn (blue-violet-red) for 1 second;
3. The machine will automatically wash for 5 mins. During washing, the filter life indicators (2-4)
are constantly lit in blue, and the system indicator (1) flashes red. The main part of the water is
draining.
4. Flush for 30 mins after washing. During flushing, the filters lifetime indicators (2-4) lights are
always on, and the system indicator (1) light flashes blue (or as an indicator (1) is also a water
quality indicator it flashes according to the present water quality situation), faucet indicator (5)
is also flashes blue.
5. When washing, be sure to carefully check the tightness of all parts of the product, wipe the
connection points with a paper tissue to see if the paper tissue is wet. Check whether the water
pipes are installed correctly and completely.
6. When the flushing is complete, turn off the purified water faucet and make sure that the faucet
does not leak, then the machine debugging is completed.
7. After washing, the whole machine enters the normal water-making state, and the system
indicator (1) and faucet indicator (5) are always blue during water supply . At this time, if you have
no need for water, turn off the faucet.

4. STEPS AFTER INSTALLATION

VERIFICATION OF THE UNIT'S OPERATING PARAMETERS
1. Measure recovery (proportion of supply water that becomes purified). You will need 1 L (1
quart) measuring cup and a stopwatch.
Open faucet (3) and measure time that the unit takes to produce 1 L (1 quart) of permeate
(purified water), then close faucet (3). Write down the result (tPermeate in the equation below).
Disconnect the red tube connected to sink drain from drain saddle. Open faucet (3) and measure
time that the unit takes to produce 1 L (1 quart) of concentrate (waste water), then close faucet
3. Write down the result (tConcentrate in the equation below). Calculate recovery using formula:
Where t is the number of seconds to obtain 1 L (1 quart) of water, R is recovery.
This manual is the intellectual property of Ecosoft. Copying and reprinting is prohibited. © 2023
13