Qspi Configuration Flash Memory; Figure 6 - Jtag Connections - Arrow CYC5000 User Manual

3.3.1.2 JTAG Chain Configuration
There are two types of configuration methods supported by CYC5000:
1. JTAG Configuration: configuration using JTAG ports. JTAG configuration scheme allows you
to directly configure the device core through JTAG pins (TDI, TDO, TMS and TCK pins). The
Quartus Prime software automatically generates a .sof that can be downloaded to the
Cyclone V with a download cable through the Quartus Prime Programmer. This function is
only available via the On-board Arrow USB Programmer2.
2. Configuration from QSPI flash: configuration using external flash. Before configuration, you
need to program the configuration data .jic into the configuration flash memory which
provides non-volatile storage for the bit stream. The information is retained within flash
memory even if the CYC5000 is turned off. When the board is powered on, the configuration
data in the flash memory is automatically loaded into the Cyclone V FPGA.
Board
FPGA Pin No.
Reference
TCK PIN_L6
TDI PIN_N6
TDO PIN_P5
TMS PIN_P6
For detailed information about how to configure the Cyclone V, please refer to

3.3.2 QSPI Configuration Flash Memory

The CYC5000 board is integrated with a 64MBit of QSPI flash memory that can be used for user
data and programming non-volatile storage. The configuration bitstream is downloaded into the
configuration device which automatically loads the configuration data into the Cyclone V when
the board is powered on. Device memory capacity not consumed storing configuration data can
be used as general-purpose non-volatile memory, which with its operation of up to 133MHz is
perfect for program and data storage. Several interfaces available with Nios II embedded
CYC5000 User Guide
Figure 6 – JTAG Connections
Pin Func.
Input Test Interface Clock
Input Test Data In
Output Test Data Out
Input Test Mode Select
Page | 13
Description
www.arrow.com
I/O Std
3.3 V
3.3 V
3.3 V
3.3 V
Chapter 6.
March 2023