Table of Contents
Advertisement
Configuring the CYC5000
After successfully compiling your project, there should new files be generated. In case of Cyclone
V devices, only the .sof file is generated automatically.
6.1
Configure the FPGA in JTAG mode
6.1.1
Connect your CYC5000 board to your PC using an USB cable. Since the Arrow USB Blaster
should be already installed, the Window's Device Manager should display the following
entries are highlighted in red (port number may differ depending on your PC). If the Arrow
USB Blaster is not installed, please refer to
6.1.2
Open the Quartus Prime Programmer from Tools → Programmer or double-click on
Program Device (Open Programmer) from the Tasks pane.
CYC5000 User Guide
Chapter 4.2
for installing the drivers.
Page | 57
www.arrow.com
March 2023
Advertisement
Table of Contents
