Chapter 3: System Setup
C
3: s
haPter
ystem
Installing a SO-DIMM Memory Module
1.
Remove the cover from the chassis by loosening the screw on the bottom
of the cover highlighted in the figure below.
Note: There is no particular order in which memory modules
should be installed in the SO-DIMM slots. It's recommended
that you install the same brand and speed of memory
modules if you want to plug them into both of the slots.
Copyright © 2023 NEXCOM International Co., Ltd. All Rights Reserved.
s
etuP
DIMM1
DIMM2
23
2.
With the bottom cover removed, install a memory module in the SO-
DIMM socket. Insert the module into the socket at an approximately
30-degree angle. Push the module down until the clips on both sides of
the socket lock into position. The gold-plated connector on the edge of
the module will almost completely disappear inside the socket.
Neu-X303mini User Manual