Chapter 3: System Setup; Installing A So-Dimm Memory Module & M.2 M Key Ssd Module - Nexcom Neu-X101 User Manual

Chapter 3: System Setup

C 3: s
haPter ystem
Installing a SO-DIMM Memory Module & M.2 M Key SSD Module (2240)
1. On the bottom of the system, loosen the screws on the bottom cover,
and remove the cover from the chassis.
Copyright © 2021 NEXCOM International Co., Ltd. All Rights Reserved.
s
etuP
26
2. Insert the M.2 SSD module into the M.2 slot at a 45 degree angle until the
gold-plated connector on the edge of the module completely disappears
inside the slot. With the module fully inserted, tighten a screw into the
mounting hole on the module to secure it.
Then, install a memory module into the SO-DIMM socket. Insert the
module into the socket at an approximately 30 degree angle. Push
the module down until the clips on both sides of the socket lock into
position. The gold-plated connector on the edge of the module will
almost completely disappear inside the socket.
SO-DIMM Socket M.2 M Key Slot
Neu-X101 User Manual