Cleaning
Switch off all units and isolate from mains before cleaning . Clean using a damp cloth . Do not use liquid or aerosol cleaners .
Repair of Faults
Disconnect all units from power supply and have it repaired by a qualified service person if any of the following occurs:
•
If any power cord or plug is damaged or frayed,
•
If a unit does not operate normally when operating instructions are followed,
•
If a unit exposed to rain/water or if any liquid has been spilled into it,
•
If a unit has been dropped or damaged,
•
If a unit shows a change in performance, indicating a need for service .
WARNING
FAILURE TO ADHERE TO THESE SAFETY INSTRUCTIONS MAY RESULT IN DAMAGE TO THE PRODUCT OR SERIOUS
BODILY INJURY.
RoHs
Our products are RoHs compliant .
Battery Disposal
The batteries contained in our products need to be disposed of as per your
local legislation acc . to EU directive 2006/66/EG .
BEFORE PUTTING INTO OPERATION
Please check that the technical data of the installation match with those of the lube meter, for example connections, pressure,
flow range and medium . Once the meter has been installed, please make sure that no air, pressure shocks or particles can
damage the meter .
Read the following information and have a thorough understanding before proceeding with meter installation Only
qualified personnel should perform meter installation
Install a strainer or Y or basket as close to the inlet side of the meter as possible . Strainers prevent dirt and other fluid
contaminants from impeding meter performance . Strainers require periodic cleaning, as clogged strainers also impede meter
performance . Contact your local representative for specific information, per your specific application .
Flow direction
April/April/Avril 2023
Strainer
Figure 1: Meter installation
AUT-UM-03446-DE-02
Bedienungsanleitung / User Manual / Manuel d´installation
Strainer
Seite / Page / Page 15