Unigas PBY1025 Manual Of Installation - Use - Maintenance page 107

Menu :
To enter the menu below, keep pushing ENTER for more than 3 s.
Menu code Sub-menu code
Prb
Log
PAS
Par
CnF
rEG
ALA
Act
rES
Loc
InF rEL
tUN
Login:
All the parameters inside the Par menu are locked by a password.
Without password, only set-points can be modified.
To login, on the log menu, press ENTER for more than 3 s. Input your password (level 2 or 3) inside PAS
With password for level 3 all the data can be set.
(tCI - Pb2 probe only for mechanical atomizing burners)
Function
Probes values
Login
Password
Parameters menu
Configuration menu
Regulation menu
Alarm menu
Active alarms
Reset alarms
Lock/Unlock functions
Software version
Autotuning
Notes
You can see in sequence the 4 probe
values (UP and DOWN keys): the probe
code is on display A (Pb1,..., Pb4) and the
probe value is on display B (not fitted or out
of work probes show "----").
It defines the access level to menu and
parameters (password)
Password input
Access to parameters (you have to login
first)
Parameter configuration
Set to set-point, probe, thresholds etc.
Access to alarm management
Show the active alarms
Reset of the manual reset alarms
Not used
Installed software version
Activation On, deactivation ESC
PID parameter autotuning
COD. M12924CA Rel. 0.5 03/2016