Table of Contents
Advertisement
en Installation and connection
Push the 4 cover caps downwards.
6.
Note: To install the transit bolts to transport the appli-
ance, perform these steps again in the reverse order.
4.5 Connecting the appliance
Connecting the water inlet hose
Connect the water inlet hose.
1.
Connect the water inlet hose to a tap
2.
(26.4 mm = 3/4").
Open the water tap carefully and check that the con-
3.
nection points are tight.
Water outlet connection types
This information is intended to help you to connect this
appliance to the water outlet.
ATTENTION!
When draining, the water outlet hose is subject to water
pressure and may come loose from the installed con-
nection point.
Secure the water outlet hose against unintentional
▶
loosening.
Note: Observe the draining heights.
The maximum draining height is 100 cm.
8
Siphon
Sink
Plastic pipe with rubber
sleeve or gully
Connecting the appliance to the electricity
supply
Note: Your electrical domestic installation for this appli-
ance must comply with the local legal provisions and
safety regulations, and should include a residual cur-
rent circuit-breaker.
Insert the mains plug of the appliance's power cable
1.
in a socket nearby.
The connection details of the appliance can be
found under Technical data → Page 30.
Check the mains plug is inserted properly.
2.
4.6 Aligning the appliance
In order to reduce noise and vibration and to prevent
the appliance from moving, align the appliance cor-
rectly.
Use a WAF 17 wrench to loosen the lock nuts in a
1.
clockwise direction.
Secure the connection
point with a (24–40 mm)
hose clamp.
Fix and secure the water
outlet hose with an elbow.
Fix and secure the water
outlet hose with an elbow.
Advertisement
Table of Contents
