Table of Contents
Advertisement
en Basic settings
16.6 Remote start
Enable the appliance for remote start via the
Home Connect app.
Note:
Remote start is deactivated for safety reasons in the
following circumstances:
¡ The appliance door is opened.
is pressed.
¡ Start/Reload
is pressed.
¡ Remote Start
¡ The appliance is switched off.
¡ Following a power cut.
Activating remote start
Requirements
¡ The appliance is connected to your home WiFi net-
work.
¡ The appliance is connected to the Home Connect
app.
¡ A programme is selected.
¡ The appliance door is closed.
¡ The detergent drawer has been pushed in.
Press Remote Start .
▶
a Remote Start
lights up and the appliance is en-
abled for remote start via the Home Connect app.
Deactivating remote start
Press Remote Start .
▶
goes out.
a Remote Start
17 Basic settings
You can configure the basic settings for your appliance to meet your needs.
17.1 Overview of basic settings
Basic setting
End signal
18
Programme position
2
16.7 Remote diagnostics
Customer Service can use Remote Diagnostics to ac-
cess your appliance if you contact them, have your ap-
pliance connected to the Home Connect server and if
Remote Diagnostics is available in the country in which
you are using the appliance.
Tip: For further information and details about the avail-
ability of Remote Diagnostics in your country, please
visit the service/support section of your local website:
www.home-connect.com.
16.8 Data protection
Please see the information on data protection.
The first time your appliance is registered on a home
network connected to the Internet, your appliance will
transmit the following types of data to the
Home Connect server (initial registration):
¡ Unique appliance identification (consisting of appli-
ance codes as well as the MAC address of the Wi-Fi
communication module installed).
¡ Security certificate of the Wi-Fi communication mod-
ule (to ensure a secure data connection).
¡ The current software and hardware version of your
appliance.
¡ Status of any previous reset to factory settings.
This initial registration prepares the Home Connect
functions for use and is only required when you want to
use the Home Connect functions for the first time.
Note: Please note that the Home Connect functions
can only be utilised with the Home Connect app. In-
formation on data protection can be retrieved in the
Home Connect app.
Value
0 (off)
1 (quiet)
2 (medium)
3 (loud)
4 (very loud)
Description
Set the volume of the sig-
nal at the end of the pro-
gramme.
Advertisement
Table of Contents
