Childproof Lock - Bosch WAV28K40AU User Manual And Installation Instructions

Hide thumbs Also See for WAV28K40AU:
Table of Contents

Advertisement

en Childproof lock
14  Childproof lock
Secure your appliance against being operated uninten-
tionally using the controls.
14.1 Activating the childproof lock
Press and hold the two Child Lock
tons for approx. 3 seconds.
a The display shows
a The control elements are locked.
a The childproof lock remains active even after the
appliance has been switched off and in the event of
a power cut.
15  Intelligent dosing system
The optimum quantities of liquid detergent and fabric
softener are dispensed automatically depending on the
programme and settings.
15.1 Starting the programme with intelligent
dosing system
If you do not want to dose liquid detergent and fabric
softener manually, use the intelligent dosing system.
This function is available depending on the selected
programme and is activated automatically.
Note:
If you are using the intelligent dosing system, do not
add additional detergent or fabric softener into the
compartment for manual dosing.
→ "Adding detergent and care product", Page 15
If you want to dose manually for a set programme,
observe the following information:
¡ Deactivate the intelligent dosing system before start-
ing the programme. The selected settings are re-
tained even after the appliance has been switched
off.
¡ Pour detergent or fabric softener into the compart-
ment for manual dosing.
→ "Adding detergent and care product", Page 15
¡ Activate the intelligent dosing system once the pro-
gramme has ended.
Requirements
¡ The laundry is prepared.
→ "Preparing the laundry", Page 14
¡ The laundry is sorted.
¡ The laundry is placed in the appliance.
→ "Loading laundry", Page 14
¡ The programme is set.
→ "Setting a programme", Page 14
¡ The intelligent dosing system is activated.
Fill the dispensers.
1.
→ "Filling the dispensers", Page 16
To replace the contents of the dispenser with an-
other product, clean the detergent drawer.
If required, adjust the basic dosage → Page 16.
2.
If required, adjust the programme settings.
3.
→ "Adjusting the programme settings", Page 14
Start the programme.
4.
→ "Starting the programme", Page 15
16
⁠   3 sec. but-
.
14.2 Deactivating the childproof lock
Requirement: To deactivate the childproof lock, the ap-
pliance must be switched on.
Press and hold the two Child Lock
tons for approx. 3 seconds.
So that the programme currently running is not can-
celled, the programme selector must be set to the
initial programme.
goes out in the display.
a
Remove the laundry.
5.
→ "Unloading the laundry", Page 15
15.2 Filling the dispensers
If you want to use the intelligent dosing system or if the
appliance displays a notification during operation of the
appliance, fill the dispensers.
Note: Fill the dispensers only with suitable detergent
and care products → Page 14.
If you want to add more liquid detergent or fabric
softener in the dispenser, use the same product.
If you want to use both dispensers for liquid detergent,
adjust the contents of the dispensers.
Requirement: The display shows a notification to fill
the dispenser.
Pull out the detergent drawer.
1.
Open the dispenser cover.
2.
Pour liquid detergent ⁠   and fabric softener
3.
the relevant dispensers.
→ "Detergent drawer", Page 10
Do not exceed the marking for the maximum fill
level when filling.
Close the dispenser cover.
4.
Note: To prevent the liquid detergent or fabric
softener from drying out, close the dispenser cover
immediately after filling.
If required, pour washing aid into the compartment
5.
for manual dosing.
→ "Adding detergent and care product", Page 15
Push in the detergent drawer.
6.
Adjust the basic dosage → Page 16.
7.
15.3 Basic dosage
The basic dosage depends on the manufacturer's in-
structions for the detergent, the water hardness and the
degree of soiling of the laundry.
Always set a basic dosage that corresponds to the
dosage for a standard load of 4.5 kg.
Adjusting the basic dosage
Press and hold
⁠   i-DOS for approx. 3 seconds.
1.
a The display shows the basic dosage set for ⁠   .
To adjust the setting, press - / +.
2.
To end the setting process, wait briefly.
3.
⁠   3 sec. but-
into

Advertisement

Table of Contents
loading

Table of Contents