Table of Contents
Advertisement
en Before using for the first time
Maintenance flap for the drain pump
1
→ Page 19
Door
2
Detergent drawer → Page 10
3
Control panel → Page 10
4
Water outlet hose → Page 8
5
5.3 Control panel
You can use the control panel to configure all functions of your appliance and to obtain information about the operat-
ing status.
1
Programmes → Page 000
1
Programme selector → Page 14
2
6 Before using for the first time
Prepare the appliance for use.
6.1 Starting an empty washing cycle
Your appliance was inspected thoroughly before leav-
ing the factory. To remove any residual water, run the
first wash cycle without any laundry.
Press
.
1.
The switch-on process takes a few seconds.
Set the
Drum Clean programme.
2.
Close the door.
3.
Pull out the detergent drawer.
4.
10
2
1
Power cord → Page 8
6
Transit bolts → Page 7
7
5.2 Detergent drawer
Note: Observe the manufacturer's instructions on the
use and dosage of the detergent and care product and
the information in the programme descriptions.
→ "Programmes", Page 000
3
Buttons → Page 12
3
Display → Page 11
4
4
3
Advertisement
Table of Contents
