Table of Contents
Advertisement
Installation location
Wooden joist floor
Kitchen unit
Against a wall
4.4 Removing the transit bolts
The appliance is secured for transportation using
transit bolts on the rear of the appliance.
Note: Keep the transit bolt screws and the sleeves in a
safe place for future transport.
→ "Inserting the transit bolts", Page 28
Pull the hoses out of the holders.
1.
Requirements
Place the appliance on a
water-resistant wooden
board (minimum thick-
ness of 30 mm) which is
screwed tightly to the
floor.
Only install the appliance
underneath a continuous
worktop that is securely
connected to adjacent
cabinets. Required niche
width: 60 cm.
Do not trap the power
cord or the hoses
between the wall and the
appliance.
Unscrew
and remove
2.
4 transit bolts using a WAF 13 wrench.
Remove the power cable from the holder.
3.
Remove the 4 sleeves.
4.
Put on the 4 cover caps.
5.
Installation and connection en
all of the screws for the
7
Advertisement
Table of Contents
