Table of Contents
Advertisement
Requirements
¡ The laundry is prepared and sorted.
→ "Laundry", Page 14
¡ The drum is empty.
Open the door.
1.
2.
Place the laundry in the drum.
Close the door.
3.
Ensure that there is no laundry trapped in the door.
13.5 Adding detergent and care product
For programmes in which intelligent dosing is not pos-
sible or desirable, you can add detergent manually.
Tip: In addition to intelligent dosing, you can also add
additional care product for laundry, e.g. stain remover,
starch or bleach, to the manual dosing compartment.
Do not add any additional detergent to the manual dos-
ing compartment to avoid overdosage and/or foaming.
Note: Observe the information about detergents and
care products → Page 14.
Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 10
3.
If required, add the care product.
Push in the detergent drawer.
4.
13.6 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 14
Press Start/Reload
▶
a The drum rotates and load detection takes place.
This can take up to 2 minutes, after which water
enters the drum.
a The display shows the programme duration or the
programme end time.
a After the programme has ended, the display shows:
End.
13.7 Soaking laundry
Note: No additional detergent is required. The washing
solution is then used for washing.
Start the programme.
1.
To pause the programme, after approx. 10 minutes,
2.
press Start/Reload
To resume the programme, after the desired soak-
3.
ing time, press Start/Reload
13.8 Adding laundry
After the programme starts, you can remove or add
laundry depending on the programme status.
Press Start/Reload
1.
The appliance pauses.
Note: If you want to add laundry, follow the instruc-
tions on the display.
→ "Display", Page 12
.
.
.
.
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press Start/Reload
5.
13.9 Cancelling the programme
Press Start/Reload
1.
2.
Open the door.
The appliance door remains locked for safety reas-
ons if the temperature and water levels are high.
– If the temperature is high, start the Rinse
gramme.
– If the water level is high, start the
gramme or select a suitable programme for
draining.
→ "Programmes", Page 000
Remove the laundry.
3.
→ "Unloading the laundry", Page 15
13.10 Resuming the programme when the
programme status is Rinse Hold
Requirements
¡ Rinse Stop is activated.
→ "Buttons", Page 13
¡ The last rinse cycle of the set programme has ended
and the laundry is in the rinsing water.
Set the
Spin programme or a programme for
1.
draining the water.
→ "Programmes", Page 000
Press Start/Reload
2.
13.11 Unloading the laundry
Open the door.
1.
Remove the laundry from the drum.
2.
13.12 Switching off the appliance
Press
.
1.
Turn off the tap.
2.
Wipe the rubber gasket dry and remove any foreign
3.
objects.
Leave the appliance door and detergent drawer
4.
open so that residual water can evaporate.
Basic operation en
.
.
Spin pro-
.
pro-
15
Advertisement
Table of Contents
