Reset Welding Task (Job) To The Factory Setting; Power-Saving Mode (Standby); Access Control - EWM T5.00-AC/DC Comfort 3.0 Operating Instructions Manual

5.4.2

Reset welding task (JOB) to the factory setting

This function resets the JOB data of a welding task (JOB) to be selected to the factory settings.
5.5

Power-saving mode (Standby)

Using the parameter
set or the mode can be deactivated > see 5.10 chapter.
When power-saving mode is activated, the machine displays show the horizontal digit in the
centre of the display only.
Actuating any operating element (e.g., turning a rotary knob) cancels the power-saving mode and the ma-
chine switches back to ready-to-weld mode.
5.6

Access control

The machine control can be locked to secure it against unauthorised or unintentional adjustment. The
access block has the following effect:
• The parameters and their settings in the machine configuration menu, Expert menu and operation se-
quence can only be viewed but not changed.
• Welding procedure and welding current polarity cannot be changed.
The parameters for setting the access block are configured in the machine configuration
menu > see 5.10 chapter.
Enabling access block
• Assign the access code for the access block: Select parameter
999).
• Enable access block: Set parameter
The access block activation is indicated by the "Access block active" signal light > see 4 chapter.
Disabling access block
• Enter the access code for the access block: Select parameter
number code (0–999).
• Disable access block: Set parameter
access block is to enter the selected number code.
099-00T500-EW501
30.1.2023
2s
Figure 5-52
in the machine configuration menu, the time for the power-saving mode can be
to access block enabled
to access block disabled
Functional characteristics
Power-saving mode (Standby)
and select a number code (0–
.
and enter the previously selected
. The only way to disable the
4s
61