How To Check That Wirelesshart Network Is Operating As Normal; How To Check That You Have A Strong Wirelesshart Mesh Network; What To Do If You Have Duplicate Tag Names; Reference Architecture - Awin Gw100 Rev.2 Connectivity For Gateway Configuration - ABB GW100 User Manual

G OO D TO K N OW
9.10 How to Check that WirelessHART Network is
Operating as Normal?
Gateway's good health status can be verified by two means:
(1) Check via LEDs status on the hardware.
(2) Check traffic light on the gateway's webpage.
Check LEDs
– ST LED is solid green.
– MESH LED is solid green, if WirelessHART devices are connected.
– ERR LED is off.
Check Gateway's Webpage
– Login as 'monitor' user.
– Check traffic LED on the 'Home' page. It should be green color.
9.11 How to Check that you have a Strong WirelessHART
Mesh Network?
– Login to the Gateway as admin user.
– Select Network Statistics page.
– Every device shall have 3 or more neighbors (recommended).
– Active path RSSI shall be better than -75 dBm (recommended).
9.12

What to do if you have Duplicate Tag Names?

Only unique tag names of devices shall be used with the AWIN GW100 rev.2. Refer to section
9.4 for details.
9.13 Reference Architecture - AWIN GW100 rev.2
Connectivity for Gateway Configuration
The user can access the webserver of the gateway by connecting to the gateway using ports
P1/P2 on the gateway itself. The user can connect directly to the gateway or via a local net-
work (See Figure
ity timer expires.
3B NP 10299 2 B
34). The user is automatically logged out of the webserver when the inactiv-
Login to the webserver is not required during normal operations. It is only needed
for setup or troubleshooting.
HO W TO CHECK THAT WIRELES SHART NET WORK IS
O PERATI NG AS NOR MA L?
5 9