Declarations And Certificates; Atex Certificate; Iecex Certificate; Ordinary Locations - ABB GW100 User Manual

BA SI C F EAT UR ES O F AWI N GW100 R EV.2
3.9

Declarations and Certificates

AWIN GW100 rev.2 holds the following certificates which makes it suitable for installation in
hazardous areas. For terms and conditions, refer to the actual certificates. For other certifi-
cates related to regional compliance and declaration of conformity visit www.abb.com.
3.9.1
The gateway is ATEX certified and is approved for the following marking. A copy of the certif-
icate can be found in the document ID 4JNO000323, available at abb.com.
3.9.2
The gateway is IECEx certified. A copy of the certificate can be found in the document ID
4JNO000325, available at abb.com.
3.9.3
The gateway has been tested and approved for installation in safe areas by UL. The ORDLOC
compliance information is available in UL File E521295, Volume D14 available at ul.com.
3.9.4
The gateway has been tested and approved for installation in hazardous areas in the US and
Canada. The HAZLOC compliance information is available in UL File E196811, Volume D11
available at ul.com
The gateway rating is as follows:
UL, USA Class I, Division 2 Groups ABCD T4
cUL, Canada Class I, Zone 2 Group IIC T4
The US National Electrical Code (NEC) and the Canadian Electrical Code (CEC) permit the use
of marked equipment in the hazardous areas. The US UL and Canadian UL standards are
based on the NEC and CEC.
3B NP 10299 2 B
To comply with FCC, IC and CE RF exposure compliance requirements, the an-
tenna used for this gateway must be installed to provide a separation distance
of at least 20 cm from all persons.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.

ATEX Certificate

IECEx Certificate

Ordinary Locations

Hazardous Locations

DE CLARAT IO NS A ND CERTIF I CATES
19