Delete A Device; Table 13: Device Information - ABB GW100 User Manual

CO NF IG UR AT IO N
Field
Device ID
Device Tag
MAC Address
Status
PV
SV
TV
QV
Battery Life
Neighbors
Timestamp
Latency
Bandwidth
Joins
Command 3 period
Command 3 status
Active Pipe
Fast Pipe Control
6.7.1
To remove a device from the list (i.e. WirelessHART network), right-click on the disconnected
device in Devices page and a delete option will appear. Select this option to confirm.
3B NP 10299 2 B

Table 13: Device Information

Description
The identification number assigned to the attached WirelessHART and
HART devices. It can be changed by using the "Edit Slave IDs" option on
the same page. See Section
Long tag of the HART device.
Displays the network card address for the corresponding WirelessHART
device.
Displays whether a device is connected or disconnected.
Displays the Primary Value of the corresponding HART device.
Displays the Secondary Value of the corresponding HART device.
Displays the Tertiary Value of the corresponding HART device.
Displays the Quaternary Value of the corresponding HART device.
Displays the expected remaining life of the battery powering the devices
(if "65535" is displayed, the device is line powered with a power supply or
waiting for battery life information to be provided by the device).
The number of neighbors a WirelessHART device can communicate with.
In (hh:mm) format, is the time when the data was most recently polled.
Measure of time it takes to respond and update all the corresponding
data fields (measured in seconds).
In (msec/packet) format, is the available data rate to the corresponding
device.
The number of times a device connected to the gateway since bootup.
HART command 3 continuous burst period.
HART command 3 burst status (ON/OFF).
This field shows the status of pipe for a device.
Note: The Active Pipe option is available in firmware version 1.5-1.
Fast pipe can be enabled and disable for a device using this function.
Notes:
Only one device can have a pipe at any point in time.
The Fast Pipe Control option is available in firmware version 1.5-1.

Delete a Device

Only devices that are not connected may be deleted from the device list.
To delete an active device, power down the device and wait until the status col-
umn indicates the device is disconnected and the row is red.
Edit Slave Device for details.
VIE W DEV ICE S
39