Table of Contents
Advertisement
6 MAINTENANCE
6
MAINTENANCE
WARNING!
The mains supply must be disconnected during cleaning and maintenance.
CAUTION!
Only persons with the appropriate electrical knowledge (authorised personnel) may
remove the safety plates.
CAUTION!
The product is covered by manufacturer's warranty. Any attempt to carry out repair
work by non-authorised service centers or personnel will invalidate the warranty.
NOTE!
Regular maintenance is important for safe and reliable operation.
NOTE!
Perform maintenance more often during severe dusty conditions.
Before each use - make sure that:
•
Product and cables are not damaged
•
The torch is clean and not damaged
6.1
Routine maintenance
Maintenance schedule during normal conditions. Check equipment prior to every use.
Interval
Every 3 months
Every 12 months or
depending on
environmental
conditions (by
authorised service
technician)
6.2
Cleaning instructions
To maintain the performance and increase the lifetime of the power source it is mandatory to
clean the product regularly. How often depends on:
•
the welding process
•
the arc time
0463 441 101
Clean or replace
unreadable labels.
Clean inside
equipment. Use dry
compressed air with
4 bar pressure.
- 21 -
Area to maintain
Clean weld terminals. Check or replace weld
cables.
© ESAB AB 2022
Advertisement
Table of Contents
