Standalone Mode; Ii.1 Quick Start: Run Single - Ametek BROOKFIELD RST Operating Instructions Manual

II. STANDALONE MODE

Standalone Mode

The following chapter summarizes the operation and the menu system of the RST Rheometer for
the performance of manual measurements without PC support.
II.1 Quick Start: Run Single
This quick start guide is intended to provide the user with instructions on the "Run Single" test
option using the touch screen display system. The Run Single test option allows the user to quickly
set up and run different rheological tests. In order to ensure safe and proper use of this instrument
to its fullest capacity, the user should read the operation manual in its entirety.
1) Assemble the RST Rheometer on a sturdy, level workbench. (Refer to Section I.3 for
installation help.)
Start-up:
2) Connect the instrument to power via the AC adapter. (The main power supply is located
behind the rheometer head for the CC and SST models and behind the rheometer base
for the CPS model.) Ensure that no spindle is attached to the instrument, and then use
the Power button to turn on the rheometer.
3) The touch screen display will turn on and display the start screen, shown in Figure II-1,
while the instrument conducts a self-test. On the right side of the start screen the instrument
model (CC, SST, CPS-F, CPS-P, or CPS-E), part number (i.e. PN: RSTSSTNNNN1N),
and the instrument's serial number (i.e. SN: 7120001) are listed.
4) If User Management is not activated, the system will display the home screen following
completion of the self-test. The home screen will appear as in Figure II-2.
AMETEK Brookfield
Figure II-1
Figure II-2
Page 24 Manual No. M14-223-B0818