Latched Mode - EWM Tetrix 352 Synergic Operating Instructions Manual

Design and function
Welding task selection
5.4.4.3

Latched mode

Selection
Sequence
1 st cycle
• Press the torch trigger 1
• The gas pre-flow time
• The arc is ignited (HF ignition).
• The start current
HF ignition shuts down).
2 cycle
nd
• Release torch trigger 1.
• The welding current increases in the up-slope time
During the main current phase, you can switch to the secondary current
trigger 1 or press and hold torch trigger 2. Lowering to the secondary current
slope time .
By tapping torch trigger 1 again or releasing torch button 2, the welding current increases with the slope
time back to the main current
menu > see 5.4.8 chapter).
3 cycle
rd
• Press torch trigger 1.
• The main current
44
Figure 5-24
Figure 5-25
expires (shielding gas flows).
flows as long as the torch trigger is held, but at least for the start time
. The slope times
drops during the down-slope time
to the main current .
in two ways: Either tap torch
takes place using the
and are set in the Expert
to the end current
(the
.
099-000141-EW501
22.03.2023