Table of Contents
Advertisement
GREASE FITTINGS
There are numerous grease fittings on the Flex-Frame Rake. Lubricating properly and often enough will
prolong the life of your rake. Grease daily during normal use and before and after storage and after
power washing. Use a good grade of high-quality grease. Make sure that grease comes out around the
shaft on sleeve type bearings. Wipe off excessive grease to prevent accumulation of chaff or grit around
the bearing.
LOCATION
Listed and shown are the description of location and number of grease fittings.
A.
(4)
One on each Gauge Wheel
B.
(6 or 8) One on each Transport Wheel Hub - (Single/Tandem)
C.
(2)
One on each Rake Arm Swing Pivot
D.
(2)
One on each Rake Arm Raise/Lower Rear Flex Pivot
E.
(2)
One on each Middle Flex Arm Pivot
F.
(1)
One on the Windrow Width Adjustment Cylinder/Jack Pivot
G.
(6)
Three on each Rear Rake Arm Linkage Pivot Assembly
B.
One on each Transport
Wheel Hub
LUBRICATION GUIDE
One on each
Rake Arm
Raise/Lower
Rear Flex Pivot
A.
One on
each
Gauge
Wheel
-20-
Shown w/optional tandem axles
D.
One on each
C.
Rake Arm
Swing Pivot
Advertisement
Table of Contents
