Network Settings - Fujitsu ApeosPrint C4030 Reference Manual

5.5

[Network Settings]

Note
Do not use the same port numbers as other ports for LPD, port 9100, HTTP-SSL/TLS communication,

primary server, and secondary server.
Do not use the same port numbers as LPD, port 9100, or HTTP-SSL/TLS communication for ports which

use HTTP (IPP, Internet services (HTTP), UPnP discovery, SOAP, WSD).
If any of the following port numbers are set, the machine may fail to operate normally due to the port

setting situation.
- 25
- 139
- 427
- 445
- 631
- 15000
[Port Settings]
Sets settings of interfaces of the machine connected to clients.
[USB]
Item
[Port Status]
[Print Mode]
[PJL]
[Auto Eject Time]
[Adobe Communication Protocol]
[Standard]
[Binary]
[TBCP]
Set to [Enabled] to use USB.
Set type of print language used. If set to [Auto], it is determined
what language is used to express data received from host, and
appropriate print processing is performed in accordance with the
data.
PJL (Printer Job Language) commands are data attached at the
beginning of an actual print job. Normally, the machine is used with
this left set to [Enabled].
Sets time from when it becomes impossible for data to be sent to the
machine until paper is ejected.
Set when printer driver output protocol is ASCII format.
Set when printer driver output protocol is BCP format.
Set when printer driver output protocol is TBCP format.
Description
5.5 [Network Settings]
83