Trouble During Printing - Fujitsu ApeosPrint C4030 Reference Manual

Symptom
The paper is dogeared.
The machine does not
feed paper from the
Bypass Tray.
Lead edge of paper is
folded over when the
paper is fed from the
Bypass Tray.

Trouble during Printing

Symptom
The Note on status display
lamp is blinking.
Unable to print.
Printing takes too much
time.
160
8 Troubleshooting
The paper is dog-eared if it is warped (curled). If the following does not
solve the problem, replace the paper.
Flatten the paper to correct the warped page.

Turn the paper over.

If Tray 1, 2, 3 or 4 has been used, use the Bypass Tray instead of it.

[Automatically Select] is selected for the [Paper Tray] setting on the
[Tray / Output] tab of the printer driver. Select [Bypass Tray] or set the
Bypass Tray for auto tray selection when [Automatically Select] is
specified.
The paper is damp. Replace the paper.
Reduce the paper loaded in the Bypass Tray to 30 sheets or less.
Change the paper loading orientation.
Feed paper from Paper Tray 1, 2, 3 or 4.
Check the error message displayed in the Control Panel and take
action to resolve the error.
Check whether the machine's IP address is set correctly.
Check the data-reception control setting.
The print data size transmitted at one time may have exceeded the
upper limit of the receivable size of the machine. This can occur when
the receiving buffer size setting is configured to [Spool to Memory].
Divide the print data into the size smaller than the maximum
receivable size of the machine. If there are multiple pieces of print
data, reduce the number of files to print at one time before printing.
The receiving buffer capacity may be insufficient. When printing high
resolution documents, reduce the memory size of unused items in
[Allocate Memory] on the Control Panel to increase the receiving
buffer capacity.
Increasing the receiving buffer capacity may improve the print
processing speed. Adjust the receiving buffer capacity according to the
print data capacity. Also, disabling an unused port and assigning the
memory for other uses is recommended.
The printing time may be shortened by changing the [Image Quality]
setting on the [Image Options] tab of your printer driver to [Standard].
Printing may take time depending on the printing method of TrueType
fonts. Set the printing method of TrueType fonts under [Specify Font]
on the [Advanced] tab of your printer driver.
The printing speed might be lower depending on the paper type such
as Heavyweight Paper or Coated Paper.
Also, if the machine internal temperature exceeds a certain level
during continuous operation, the machine lowers the print speed. If
operation is still continued or the internal temperature rises further,
the machine stops operation due to the error. In that case, switch the
machine power off, wait for a while until the machine's internal
temperature drops, and then switch the power on again.
Cause/Remedy
Cause/Remedy